Bollhoff RIVCLINCH 0201 FS, Руководство пользователя

Страница: 13 / 42

ATTEXOR Clinch Systems SA User manual
Copyright © 2010 by Bollhoff Attexor S.A. Page 13
Installation, Connections
Fixing, suspension
Ref. Fig. 2, Fig. 8
The normal use of the machine is hand operated, suspended by means of a rotator (A10),
and hooked to a balancer, delivered as an option. The following precautions must be
observed:
•
Select a hooking position for the booster (C1) which is at least 0.5 m above the
highest working position of the work head and suspend it by the ring (C7).
•
Verify that the suspension points of your installation are sufficiently strong, and
check that the eventual supporting structure is able to carry the weight of all the
attached equipments. Verify the total weight of your equipment. Usually the total
machine weight may be as high as 15 kg, including the booster and the balancer.
Notice: Take into account that the booster operation may produce vibrations in the
installation. The booster can be attached to the suspension using a spring in order
to reduce vibration.
•
Check that all the suspended equipment (booster, balancer) is secured by an
additional safety cable. Contact your distributor in case of any doubt.
•
Booster safety cable must be passed through holes provided therefore on the top
plate, must be attached to an independent suspension of the normal attachment
of the booster. It must provide a race fall of 100mm. The cable clamp must be
blocked on two sections of cable doubled. They must be tightened after a first test
suspension. Ref. Fig.8.
•
Balancer safety cable: refer to the manual delivered with the balancer.
•
Suspend the work head by the ring (A10) or preferably by the rotator delivered as
option situated between the handle and the jaw to the hook of the balancer, and
observe the instruction manual of the balancer unit.
•
During all the above preparation, check that the air and oil hoses connected to the
handgrip (B2) are always free of tension bending, which may occur in case of
excessive rotation of the work head.
•
Min bending radius of the flexible hydraulic hose = 100mm (4")
•
Installing the booster and the workhead in a place where the lighting is at least
300 lux so as to check the oil level and to work in good conditions.