06
© Böhmer-AG 2020
AG-178FD / AG-192FD
Assembly
If the electric start switch block has been supplied unassembled, it will require attachment to the engine and the wiring connected. Attach the
switch block (B) to the brackets on the engine using the 2 supplied bolts. The mounting brackets on the engine may vary slightly between models,
however, the switch block is always located next to the starter motor. Connect wires as follows:
No.
Wire Colour
Use
01
Green
Ignition
02
Red
Starter Motor Power
03
White
Starter Motor Earth
Typically, most engines are fully assembled, however, some models may
require the following assembly (as applicable). The image below shows
an unassembled electric start model with exhaust shroud.
Electric Start
Exhaust Shroud
Place the shroud (A) over the exhaust port – generally with the opening
facing down, and attach it using the 4 supplied screws.
A
01
03
02
04
05
No.
On Engine
Use
04
Push Terminal
Connect to ‘3’
05
Blue Wire
Connect to ‘1’
06
Earth Terminal
Connect to ‘2’
06
