0007 00
BOH-PM-13-2
Chapter 2 Rev. 0.01
0007 00-1
OPERATOR INSTRUCTIONS
FPU
®
SYSTEMS OPERATION MANUAL
BOH OFFICE MODULE
(INCLUDING REPAIR PARTS & SPECIAL TOOL LIST)
BOH FPU Field Pack-up Units
PREPARATION FOR MOVEMENT AND TRANSPORT
Prior to moving the office module either by forklift or within a container, all internal and external
components must be properly secured. These tasks include, but are not limited to, the following:
•
Lowering the roof height as necessary to fit in transport vehicle
•
Securing office equipment utilizing ratchet straps provided on upper shelf
•
Securing jack assembly components
•
Retracting HVAC unit
•
Securing both desk chairs to desk utilizing restraint straps provided
Fork Pockets
The Office Module is provided with fork pockets in the rear and both sides of the container to facilitate
lifting, positioning and loading of the module on FPU containers, transport vehicles and site locations. The
office module must be loaded into the FPU container using the rear fork pockets (1) with the door facing
out the side of the container. The side fork pockets (2) are typically used for positioning of the office
module once outside the container even though the rear fork pockets could be used for this purpose as
well.
CAUTION
The office module must be loaded into the FPU-8 or 8-foot section of the FPU-20 container using the rear
fork pockets which will orient the office module with the door facing out the side of the container. The
office module feet are designed to fit in some, but not all, of the available foot pads set in the container
floor cradle. Failure to load the office module in this orientation may result in damage to the container
and/or office module. This configuration also allows access into the office module when loaded inside the
container.
Module Rear
2
2
Module Front (Left)
Module Front (Right)
1
Office Module tare weight 3,500 lb.
