BOH Enviromental 8145-01-502-3927, Руководство пользователя

Страница: 40 / 70

Field Pack-Up (FPU
®
) Series
5.1.4 The sequence for deploying the workstations is as follows:
1. Remove the workstation retention pins located outside the container (3) and attached to each
side of the workstation. See Fig. 5.2-1.
2. After electrical power, ground connection and lighting has been established, two personnel
should enter the container, one from the main entrance door (1) and the other from the
secondary entrance door (2).
See Fig. 5.1-1.
3. At this point the ratchet straps (2) and pins (1) from both workstations may now be removed
and workstations A and B may be deployed. See Fig. 5.1-2.
4. Secure the workstations A and B with pins (1) to prevent their movement. See Fig. 5.1-2.
5. Proceed to third workstation C next to the main entrance door and remove the pins (1) and
ratchet straps (2) and deploy the workstation. See Fig. 5.1-2.
6. Secure the workstation C with pins (1) to prevent its movement. See Fig. 5.1-2.
5.2
EWCC WorkStation Preparation for Shipment
5.2.1
Retracting and securing sequence for the three workstations is as follows:
1. Remove the securing pins from workstation A with assistance from other personnel from the
exterior of the container, push the workstation (1) until fully retracted and the hand holds (2)
are together and outer seal (3) makes good contact.
See Fig. 5.2-1.
Figure 5.2-1
Retracting the Work-Stations
2. Secure the workstation with the pins (1) and ratchet straps (2). See Fig. 5.1-2.
3. Remove the securing pins (3) from workstation B with assistance from other personnel from
the exterior of the container, push the workstation until fully retracted and the outer seal
makes good contact.
4. Secure the workstation with the pins (1) and ratchet straps (2). See Figure 5.1-2.
5. Proceed to third workstation C next to the main entrance door and remove the securing pins
(1) with assistance from other personnel from the exterior of the container, push the
workstation (1) until fully retracted and the outer seal (3) makes good contact.
6. Secure the workstation with the pins (1) and ratchet straps (2).
See Figure 5.1.2. Re-attach
Workstation retention pins located outside the container.
1
2 3
19