Bodytastic TurboSpin 96RV, Руководство пользователя

Страница: 20 / 28

18
Owner’s Manual
MAINTENANCE

Chain Tension adjustment
The chain tension had been set and lubricated before shipped. It should not
need to be adjusted when first using. However, you may need to make the
minor tension adjustment over time.
Note: Make sure you adjust both side equally, either tighten or loosen the
chain tension so that the flywheel keep in alignment with the frame
Tighten the Chain tension
Move the crank arms back and forth. If there is more than 1/4” (0.64cm)
movement in the crank before flywheel starts turning, you will need to adjust
the chain.
1. Loosen the two-flanged nut(A) on either side of
flywheel.
2. Moving the flywheel forward by evenly tightening
clockwise the 2 hex bolts(B), which go through the
frame tube until there is approximately 1/4” (0.64cm)
of slack in the chain.
3. Re-tighten the two-flanged nut on either side of
flywheel and then put back the safety cover.
Loosen the Chain tension
1. Normally the rider will feel the strong vibration in the lower RPMs
(20-50RPMs) if the chain is too tight. If this happened, you will need to
adjust the chain.
2. Loosen the two-flanged nut on either side of flywheel.
3. Moving the flywheel backward by evenly loosening counterclockwise the
2 Hex bolts which go through the frame tube. Suggest turning 1/2 turn.
4. Re-tighten the 2 flanged nut on either side of flywheel and then put back
the safety cover
5. You will need to repeat the step if you still feel vibration after adjustment
A
B