BIKES – OWNER’S MANUAL
35
5. DIAGNOSTICS MENU
Accessing the DIAGNOSTICS Menu
:
1. Hold the
iTek
key for 3 seconds to have access to the DIAGNOSTICS Menu
When accessing the DIAGNOSTICS Menu the version of the software installed in the console will display.
The software version will scroll across the alphanumeric screen. This information is helpful in diagnosing certain computer-
related conditions. Keep in mind that the version number may change depending on the model number of your bike.
To perform any of the below tests, press the
INCREASE/DECREASE SPEED
keys to select the one you wish to test and
press the
JustGo
TM
key to accept.
Diagnostics
V6X-V9X
R6X-R9X
5.1 NVRAM Test
5.1
5.1
5.2 Keypad Test
5.2
5.2
5.3 Display Test
5.3
5.3
5.4 Heart Rate Test
5.4
5.4
5.5 Sound Test
5.5
5.5
5.6 Clock Test
5.6
5.6
5.7 USB Port Test
5.7
5.7
5.8 Brake Test
5.8
5.8
5.9 Speed Sensor Test
5.9
5.9
5.10 Statistics
5.10
5.10
5.1. NVRAM TEST
The NVRAM is a memory chip that saves information even when the computer is OFF. The NVRAM test lets you know if the
memory chip is functioning correctly. Note that the NVRAM (non-volatile memory) test
will not
erase any stored information.
1. Enter the DIAGNOSTICS Menu, select NVRAM TEST and press the
JustGo
TM
key to accept.
2. The computer will display the following message: ‘’SUCCESSFUL’’.
3. Press the
STOP
key to terminate the test.
5.2. KEYPAD TEST
The keypad test allows you to verify that each key is responding correctly when pressed.
1. In the DIAGNOSTICS Menu, select KEYPAD TEST and press the
JustGo
TM
key to accept.
2. Press each key, one at a time, and check the confirmed response on the screen. For example, if you press the
INCREASE LEVEL
key, the screen will display LEVEL INC, indicating that the key press was recognized.
3. Press the
STOP
key to terminate the test
5.3. DISPLAY TEST
The display test allows you to verify that each display light is working properly. If you notice that one or more areas on the
screen do not light up while you exercise, you should perform this test.
1. In the DIAGNOSTICS Menu, select DISPLAY TEST and press the
JustGo
TM
key to accept.
2. The screen will light up in a certain way. To proceed to the next display pattern, press the
INCREASE/DECREASE
SPEED
keys.
3. Press the
STOP
key to terminate the test.
Содержание R6X
Страница 2: ......