Step 2 Seat & Back Pad
1.
Attach the Seat Pad (28) to the Seat Frame (5) using four M8 Spring Washers (99) and four
M8 x 20L Hex Head Threaded Bolts (77) as shown in Fig. B1. Tighten these bolts.
2.
Attach the Back Support Frame (8) to the Seat Frame (5) using two 1/2" x 3-1/2" Hex Head
Bolts (74) and two 1/2" Nylon Nuts (103). Tighten these bolts, then cap each end with four
1/2" Caps (109).
3.
Attach the Back Pad (18) to the Back Support Frame (8) using two M8 Washers (92) and
two Back Pad Adjustment Knobs (10). You will be able to use the knobs to adjust the back
support for your comfort.
Step 1 Front & Rear Stabilizer
1. Use a Styrofoam block from the packing material to raise the front of the Bike Assembly (1)
then attach the Front Stabilizer (2) using two 3/8" x 2-1/4" Hex Head Bolts (79), as shown in
Fig. A2. Tighten these bolts. Remove the Styrofoam block.
2.
Use a Styrofoam block from the packing material to raise the rear of the Bike Assembly (1)
then attach the Rear Stabilizer (3) using two 3/8" x 2-3/4" Hex Head Bolts (75), two 3/8"
Spring Washers (98), and two 3/8" Acorn Nuts (110), as shown in Fig. A3. Tighten these bolts.
Remove the Styrofoam block.
3.
Once the bike is in its final location, there are Adjustable Levelers (44) under each end of
the Rear Stabilizer (3) that need to be adjusted to ensure the bike is totally stable on the floor.
A3
75
3
1
110
44
45
44
45
98
A2
79
2
1
A1
ASSEMBLY
3
