STEP 3 Assemble Base Frame
7
1. Attach Front Upright Frame (3) to the Base Frame (1) using two
3/8" X 1" Hex Threaded Bolts (33) and two 3/8" Spring Washers
(37).
2. Attach two Swivel Pulley Housings (8) to the Cable Height
Adjuster (7) using two 1/2" X 4-1/4" Hex Bolts (29), four 1/2"
Washres (36), and two 1/2" Nylon Nuts (40). Slide the Cable
Height Adjuster (7) over the top of the Rear Upright Frame (3).
Stop at your desired height by locking the Knob (26).
3. Slide two Stack Spacers (43) and two Rubber Donuts (14) onto
one end of each Guide Rod (5) and then insert Guide Rod (5)
into the Plastic Guide Rod Holders (15) in Base Frame (1) as
shown.
4. Slide each Weight Plate (13) over Guide Rods (5). Make certain
that each plate is oriented with selector hole on bottom and
facing forward. Attach Top Plate (12) to Selector Rod (11) using
Top Plate Bolt (35). Slide Top Plate (12) and Selector Rod (11)
over Guide Rods (7). Tighten the bolts.
NOTE:
If you have purchase 19 piece of Weight Plate (13).
Please
DO NOT
install Stack Spacers (43) on the follow step.
