20
STEP 13 WEIGHT STACK SHROUDS & ACRYLIC PANELS
ASSEMBLY IS COMPLETE !
Tighten all bolts gradually from bottom of Main Frame (1).
When attaching the Acrylic Panels, be careful not to over tighten the screws.
Cracked Panels due to over tightening are not covered under warranty.
1. Attach Weight Stack Shroud (45, 46L, 46R) to the tabs welded on Rear Stabilizer (2)
as shown, using eight 5/16" X 1/2" Screws (150) and eight 5/16" Washers (165).
2. Attach two Acrylic Panel Trims (44) to the tabs welded on the Front Upright (3), using
four M6 X 70L Round Screws (151) and four Plastic Studs (115).
3. Attach two L Plates (33) to each side of the Weight Stack Shrouds (46L & 46R) using
one M6 X 12L Screws (147) and two M6 Cap Nuts (176).
4. Attach the Acrylic panels (54L & 54R) to the L Plates using M6 X 12L Screws (147)
and M6 Cap Nuts (176). Attach the Acrylic Panels (54L & 54R) and Acrylic Panel
Trim (44) to the Front Upright (3) using M6 X 70L Round Screws (151). Be sure to
place Plastic Studs (115) in between the Acrylic Panels (54R & 54L) and the Front
Upright (3).
DO NOT OVER TIGHTEN THE SCREWS! CRACKED PANELS DUE TO OVER
TIGHTEN ARE NOT COVERED UNDER WARRANTY.
5. Attach the Top Acrylic Panels (55R & 55L) and Top Panel Trim (43) to the Top Frame
(4) using two M6 X 12L Screws (147).
DO NOT OVER TIGHTEN THE SCREWS! CRACKED PANELS DUE TO OVER
TIGHTEN ARE NOT COVERED UNDER WARRANTY.
6. Attach Bottle Cage (68) to the Right Weight Shroud (46R), using two M5 X 12L
Screws (155) and two M5 Nylon Nuts (172).
