11
STEP 5 PRESS ARM ASSEMBLY
35
4
9
38
7
56
74
160
103
160
169
103
153
158
125
158
147
147
102
102
147
169
1. Attach the Press Arm Support (9) to the Top Frame (4) by aligning the holes and inserting
the Axle (35). Secure the Axle (35) using two 1/2" Larger Washers (160) and two 1/2"
Nylon Nuts (169). Tighten these 1/2" Nylon Nuts (169) and then cap with two 1/2" Cap
Nuts (103).
2. Attach the Press Arm (7) to the Press Arm Support (9) by aligning the holes and inserting
the Press Arm Axle (38). Make sure the Longer Pop Pin (125) is inserted into one of the
adjustment holes in the Press Arm Support (9). Secure the Press Arm Axle (38) by
tightening the pre-assembled 5/16" X 1/4" Set Screw (158). Attach the Plastic Cover (74)
to the front of the Press Arm Support (9) and secure using one M5 X 2-1/2" Screw (153).
3. Attach Press Arm Panel (56) to Press Arm (7), using four M6 X 12L Male Screws (147) and
two End Caps (102) to bottom tube of Press Arm (7).
