13
STEP 7 INSTALL TOP CABLE
Assemble cables and pulleys simultaneously.
1. Insert the threaded end of Top Cable (82) into slot in the front of Top Frame (4), over T1
and pulley T2 mounted on the Top Frame (4), using one 3/8" X 109.5L Flat Pin Bolt
(140) and M6 X 12L Male Screw (147) each.
2. Route cable down and around pulley T3 (left side at Press Arm Support (9) as if you are
seated) using one 3/8" X 55L Flat Pin Bolt (142) and M6 X 12L Male Screw (147).
Route cable around pulley T4 mounted on the Front Upright (3), using one 3/8" X 30.5L
Flat Pin Bolt (146) and M6 X 12L Male Screw (147), entering to the underside, exiting
on top, as shown in Fig. Step 2-1, continue routing around pulley T5 {right side pulley
mounted in Press Arm Support (9)}, entering on top, exiting on bottom as shown in Fig.
Step 2-2.
3. Route cable under pulley T6 mounted in the slot in Front Upright (3), using one 3/8" X
109.5L Flat Pin Bolt (140) and M6 X 12L Male Screw (147). Continue routing cable up
to pulley T7 mounted to rear top Front Upright (3), using one 3/8" X 30.5L Flat Pin Bolt
(146) and M6 X 12L Male Screw (147). Route over T7 and down to pulley T8 mounted
in the closed end of the Adj. Pulley Block (23), using one 3/8" X 30.5L Flat Pin Bolt
(146) and M6 X 12L Male Screw (147). The Adj. Pulley Block (23) does not attach to
the frame, it dangles.
4. Route cable up and over pulley T9 mounted on Top Frame (4), using one 3/8" X 55L
Flat Pin Bolt (142) and M6 X 12L Male Screw (147) and down around pulley T10
mounted at top closed end of Double Pulley Block (23), using one 3/8" X 30.5L Flat Pin
Bolt (146) and M6 X 12L Male Screw (147).
5. Route cable up and over pulley T11, using 3/8" X 30.5L Flat Pin Bolt (146) and M6 X
12L Male Screw (147) and down to screw the threaded end of the cable into the Top
Plate (58) about half way down. The threaded end of the cable is an adjustment point,
but should always have at least one third of the threads screwed into the Top Plate (58).
When all cables are strung and cables adjusted, make sure to tighten the jam nut.
TOP CABLE (82)
Threaded End
Ball End
