ASSEMBLY- STEP 3
**Note
：
Do Not fully tighten frame bolts and nuts until after completing Step 3
**Note
：
Do Not fully tighten pulley bolts and nuts until after cable routing
The following Parts and Hardware will be needed to complete Step 3
Parts Description
Hardware Description
Qty Part Part
Description Qty
Part Part
Description
15
D29
Weight Stack Plates
2
A2
3/8
"
×
3
"
hex head bolt
1
I
Top Weight Stack Frame
1
A5
3/8
"
×
1
¾
"
hex head bolt
2
Q
Guide Rods
1
A10
Selector pin
1 S
2
"
×
5
½
"
Plate
1
A12
3/8
"
×
2
"
round bolt
1
A13
3/8
"
×
2
"
hex head bolt
4
B2
3/8
"
nylon lock nut
8
C1
3/8”
I.D.
washer
1
C5
3/8” spring washer
1
D1
2
"
×
2
"
×
1.8t end cap
2
D9
phi
2
½
"
rubber donut
2
D14
4
¼
"
pulley
1
D17
top
plate
1
D18
weight selector bar
2 D28 phi3/4” shaft collar
Step by Step
1. Place 2 (D9) on (O) - Rear Base Frame, slide 2 (Q) - Guide Rods into 2 (D9) and (O)-
Rear Base Frame
2. Slide 15 (D29) - Weight Stack Plates onto 2 (Q) - Guide Rods (note
：
make sure housing
for selector pin on Weight Stack Plates is facing forward as shown)
3. Slide (D17) - Top Plate noto 2 (Q) - Guide Rods (note:make sure that housing for (A12)
- Round Bolt is facing forward as shown)
4. Slide (D18) - Selector Shaft into center of weight stack. Connect (D17) - Top Plate to
(D18) - Selector Shaft using (A12) - Round Bolt
5. Slide 2 (D28) - Shaft Collars onto 2 (Q) - Guide Rods (note
：
If (D28) - Shaft Collars do
not slide onto 2 (Q) - Guide Rods, make sure that the allen head screws in (D28) are
loose)
6. Attach (S) 2
"
×
5
½
"
Plate and (I) - Top Weight Stack Frame to (D) - Top Frame and 2 (Q) -
Guide Rods
7. Secure 2 (D28) into (I) - Top Weight Stack Frame. Re-tighten allen head screws
8. Attach 2 (D14) pulleys to frame to (I) - Top Weight Stack Frame as shown (Note
：
Do Not
fully tighten pulley bolts and nuts until after cable routing)
Securely Tighten All Frame Bolts Used in Steps 1-3, (Note
：
Leave Pulley Bolts Loose
Until Cable Routing)
EXM-1500G ASSEMBLY INSTRUCTIONS
Page 11
EXM1500G-112003
