ASSEMBLY- STEP 2
**Note
:
Do Not fully tighten frame bolts and nuts until after completing Step 3
**Note
:
Do Not fully tighten pulley bolts and nuts until after cable routing
The following Parts and Hardware will be needed to complete Step 2
Parts Description
Hardware Description
Qty Part Part
Description Qty
Part Part
Description
1 D
Top
Frame
4 A3
3/8
"
×
2
¾
"
hex head bolt
1
E
Bench Press Frame
2
A4
3/8
"
×
2
½
"
hex head bolt
1
R
Foam Roller Bar
1
A5
3/8
"
×
1
3/4
"
hex head bolt
1 T
2
"
×
4
"
Plate
3 B2
3/8
"
nylon lock nut
6
C1
3/8
"
I.D. washer
3
D1
2
"
×
2
"
×
1.8t round end cap
2
D6
phi 1
"
round end cap
4
D11
phi 16 nylon bushing
3
D14
4
¼
"
pulley
2
D16
phi 3
½
"
×
8
"
foam roller
2
D25
phi 3
"
nylon washer
2
D30
Round end cap
2
D31
Round end cap
Step by Step
1. Attach (D) - Top Frame to (C) - Angled Support Pillar
2. Attach (D) - Top Frame to (B) - Vertical Support Pillar and (T) - 2"
×
4" Plate
3. Attach (R) - Foam Roller Bar to (B - Vertical Support Pillar using 2 (D16), 2 (D25), and
2 (D6)
4. Loosen allen head screws at the bottom of (E) - Bench Press Frame. Slide out pivot
shaft inside of (E) - Bench Press Frame.
5. Attach (E) - Bench Press Frame to (A) - Main Base Frame, (note
:
once (E) and (A) are
attached and pivot shaft is back in place, re-tighten allen head screws at the bottom
of (E)
6. Attach 3 (D14) pulleys to frame to (E) - Bench Press Frame and (D) - Top Frame as
shown
(Note
:
Do Not fully tighten pulley bolts and nuts until after cable routing)
(Note: When attaching the (D14) Pulley to (E) Bench Press Frame the threaded side
of the pulley bolts must face the right side if you are standing in front of the unit,
facing the unit.)
EXM-1500G ASSEMBLY INSTRUCTIONS
Page 9
EXM1500G-112003