6
There is a limited current setting in the factory, forbidden the dangerous output.
Ensure the machine is connected to the ground wire during working.
The room which place the machine should be tidy and dry, ensure no liquid products put
on the machine
，
like: Water, oil. during the machine working
。
Attention
Please stop to use the machine if there is any fault, and contact supplier immediately.
4.4 Fire
Dangerous
Avoid laser and laser beam close to flammable, anesthetic or other flammable solvent. Paper
and plastic products shall not be placed in the laser working area. These materials will result
in the combustion, within a certain distance. When the machine is not working, or in the
replacement of patient, the treatment of intermittent process, adjust the machine to “Standby”,
under this condition the, pedal switch can’t be used.
4.5 Prevent the scattering of laser beams
Avoid laser beam focused on flammable material, otherwise it will cause combustion.
The hand piece should be placed in working area, and only can be controlled by the
operator, forbidden to be operated by any third person.
4.6 Manual recovery
Under any abnormal condition, there will be warning in the machine; the machine should
be turned off. Cut off the power by key switch, then restart the power, let the machine
restart, if there is still any fault in the machine, please contact supplier or representatives.
4.7 Marks on the machine
HANDLE
：
This is for install the handle
INTERLOCK
：
Safety locks for the machine and operation room
FOOTSWITCH
：
Here is for connect the foot switch
WATER INLET/WATER OUTLET
：
To fill or drain out water
ON/OFF
：
Key switch
EMERGENCY SWITCH
：
For emergency stop
