Body Champ TRIO-TRAINER BRT1875, Руководство пользователя

Страница: 15 / 24

BRT1875 BRT2885 Page 13
Assembly STEP 7
Hardware Required
Start with loosening the pre-assembled Spring Loaded Knob (#53)
and pull back slightly on it so that you may proceed to insert the Seat
Post (#08) into the opening of the post that is protruding from the Main
Frame (#01) down a minimum of four inches so that the corresponding
holes can engage. Screw in the Spring Loaded Knob (#53) through
the Main Frame (#01) and then through any one of the holes located
on the Seat Post (#08) .
Note: The Spring Loaded Knob (#53) has a safety feature that
allows you to loosen it by turning it counter-clockwise three times
as you pull it outward. This knob can be loosened to adjust the seat
height. Adjust the seat height and then release the knob back in.
Tighten the knob by turning clockwise.
Remove the two Lock Knobs (#55) and two Washers (#34) that are
pre-assembled on the Seat Cushion Frame (#09) . Slide the Seat
Cushion Frame (#09) onto the trough of the Seat Post (#08) as
shown below. Secure using two Lock Knobs (#55) through two
Washers (#34) .
Attach Backrest Cushion Frame (#10) to the Seat Cushion Frame
(#09) and secure by using two Bolts (#26) , two Spring Washers
(#38) , two Washers (#33) .
With the help of an assistant, align the four of the Left Rear Handle
Bar (#11) and Right Rear Handle Bar (#12) to the holes on the
Backrest Cushion Frame (#10) and secure all using the two Hex
Bolts (#23) and two Nylon Nuts (#40) .
#55 Knob (M10)
[2 pieces]
#34 Washer (M10)
[2 pieces]
#53 Spring Loaded Knob
(M16)
[1 piece]
#26 Bolt (M8x20mm)
[2 pieces]
#38 Spring Washer (M8)
[2 pieces]
#33 Washer (M8)
[2 pieces]
#23 Hex Bolt (M8x60mm)
[2 pieces]
#40 Nylon Nut (M8)
[2 pieces]