Body Champ BRM3635, Руководство пользователя

Страница: 14 / 24

Assembly STEP 7
Hardware Required
02
11
A. PULSE HANLDE BAR
Install the Pulse Handle Bar (#05) onto the bracket of the
Center Post (#02) as shown in the illustration below using two
Bolts (#19) and two Spring Washers (#29) .
Attach the Pulse Handle Bar Cover (#24) to the center of the
Pulse Handle Bar (#05) .
Please ensure the Pulse Sensor Wire (#13) is free and clear,
avoiding pinching it during this assembly step. You will need
to connect this wire to the Monitor (#46) later.
B. MONITOR ASSEMBLY
Remove Screws (#25) f rom the back of Monitor (#46) a nd set
them aside as they will be used later for this step.
Connect the Monitor Wire (Upper) (#11) to the Monitor (#46)
and connect the Pulse Sensor Wire (#13) to the Monitor
(#46) . Secure the Monitor (#46) to the bracket of the Center
Post (#02) using four Screws (#25) .
Tension Adjustment
To increase the tension (+ higher level of
intensity), turn the Tension Controller (#16)
in a clockwise direction.
To decrease the tension (- lower level of
intensity), turn the Tension Controller (#16)
in a counter-clockwise direction.
"1" is the lowest level of tension (easiest
level for workout);
"8" is the highest level of tension (most
difficult level for workout).
THE ASSEMBLY PROCESS IS NOW COMPLETE.
However, for your own safety, please make sure to read this entire Owner’s
Manual which includes safety instructions and warnings, as well as any safety/
warning labels affixed to the product before use.
For your safety , please visually and functionally inspect and test the unit
after assembly is complete.
#24
Pulse Handle Bar Cover
[1 piece]
#19
Bolt (M8x30 mm)
[ 2 pieces]
#29
Spring Washer (M8)
[2 pieces]
#25
Screw (M5x10 mm)
[4 pieces]
BRM3635/BRM3810 Page 12