Body Champ BRM3635, Руководство пользователя

Страница: 9 / 24

Assembly STEP 2
A. MONITOR WIRE & TENSION WIRE ASSEMBLY
Connect the Monitor Wire (Upper) (#11) to the Monitor Wire (Lower)
(#12) and then follow the instructions in the diagram below to connect
the Tension Wire (#70) .
Remove four Bolts (#16) , four Spring Washers (#29) , and four Arc
Washers
(#36)
that are pre-assembled on the Main Frame
(#01)
and
set them aside as they will be used later in this step.
After connecting the Tension Wire (#70) to the Tension Controller
(#72) slide the Center Post (#02) onto the Main Frame (#01) and
secure it using the four Bolts (#16) , four Spring Washers (#29) , and
four Arc Washers
(#36).
B. SEAT POST ASSEMBLY
Insert the Seat Post (#47) into the mouth of the post that is protruding
from the Main Frame (#01) down a minimum of 4 inches to engage
the lowest hole. Make sure the holes on the Seat Post
(#47)
are
facing the front before inserting. Secure the Seat Post (#47) using the
Spring Loaded Knob (#49) .
Hardware Required
11
12
72
70
Tension Wire Assembly
Insert the tip of the Tension Controller (#72) wire into the
Tension Wire (#70) head at an angle.
Tilt the Tension Controller (#72) wire into the crevice and
then pull upward.
#16
Bolt (M8x20 mm)
[4 pieces]
#29
Spring Washer (M8)
[4 pieces]
#36
Arc Washer (M8)
[4 pieces]
BRM3635/BRM3810 Page 7