Assembly Instructions
BRB 5007
A s s e m b l y S t e p 1
Page 5
H a r d w a r e R e q u i r e d
Bolt
#22. Carriage Bolt (M8x65 mm)
[4 pieces]
#28. Screw (M5x8 mm)
[2 pieces]
Washer
#32. Arc Washer (M8)
[4 pieces]
Nut
#31. Nut (M8)
[4 pieces]
A
C
B
A.) Bottom Frame Assembly
Attach the
Rear Stabilizer (#03)
to the
Bottom Frame (#02)
using two
Carriage Bolts (#22)
, two
Arc Washers (#32)
and
two
Nylon Nuts (#31)
.
B.) Stabilizer Assembly
Attach the
Front Stabilizer (#04)
to the
Main Frame (#01)
using two
Carriage Bolts (#22)
, two
Arc Washers (#32)
and
two
Nylon Nuts (#31).
Please Note,
Front Stabilizer (#04)
is
the one with end caps that spin.
C.) Frame Assembly
Connect
Sensor Wire 4 (#41)
to
Sensor Wire 5 (#42)
as
illustrated.
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust bottom frame
simultaneously.
Push knob back inward until it clicks and then
tighten it by turning clockwise.
Pull the
Spring Loaded Knob (#15)
outward and then slide the
Bottom Frame (#02)
into the
Main Frame (#01).
Secure the
Slide the
Bottom Frame (#02)
farther into the
Main Frame
(#01)
for shorter users and farther out for taller users. Once you
select the desired setting, screw the
Spring Loaded Knob (#15)
up into the
Main Frame (#01)
and through the
Bottom Frame
(#02)
. The
Spring Loaded Knob (#15)
has a safety feature that
allows you to loosen it by turning it counter clockwise three times
as you pull it outward. Adjust the
Bottom Frame (#02)
and then
pop the
Spring Loaded Knob (#15)
back in. Tighten the knob by
turning clockwise. See the illustration below.
Main Frame Sleeve (#17)
to the
Main Frame (#01)
together
by using two
Screws (#28).
Stability Knob
The
Knob Bolt (#16)
comes pre-assembled on the unit and serves to
enhance its safety and stability. No installation or adjustments are
necessary.
