If the belt does not catch hold of the flywheel, it is time for
it to be tightened.
Do not adjust this if you don’t have the
right tools. Check step 5.
1) Remove the service hatch on both sides of the cycle.
See figure 23.
2) Loosen the bolts (1) on both sides of the cycle with a 19
mm wrench, See figure 27
3) Loosen the nuts (2) on the counter bolt on both sides
of the cycle with a 10 mm wrench, see figure 27.
4) Use a wrench to tighten the counter bolts (3). On the
right side, the tool should be pulled downwards and on
the left side upwards to tighten with a 10 mm wrench.
5) The belt should be tightened to approximately 125
kg/229 Hz. To measure this, a special device can be
bought at your local BODY BIKE® distributor. Go to page
30.
6) Tighten the counter bolt (2) on both sides of the cycle
again.
7) And tighten the bolt(1) again on both sides of the cycle.
8) Close the cycle by fastening the two hatches again.
POLY-V BELT
PLEASE NOTE
The belt should be evenly tightened on both
sides.
The flywheel should be parallel with the long
main side member.
!
1
2
3
Figure 27
024
Содержание SMART+
Страница 1: ...01 INSTRUCTIONS BODY BIKE INDOOR CYCLE BODY BIKE SMART ENGLISH ...
Страница 8: ...Unpacking 9 Bottom frame 9 10 Handlebar 11 Bottleholder 11 Saddle 12 Pedals 13 14 ASSEMBLY 08 ...
Страница 14: ...Figure 9 Figure 10 Figure 11 Tighten in the direction of the handlebar Point upwards 014 ...