25
Unintended system activation/adjustment
In the event of an unintended activation or adjustment of the
system, too early lowering, a loss of the position occurs. This
may e.g. result from the replacement of the drives. In order to
remove the fault, it will be necessary to carry out an initialization.
The initialization is made through a button combination, i.e. by
pushing the third button row at the top side of the control (auto
contour). Just push both buttons and keep hold of them until the
initialization is fully completed. After five seconds, all drives will
be lowered at half pace. Owing to the reduced pace, it is possi-
ble to provide for the prevention of collisions in a timely
manner.
Position reset after MSE-release
Due to the release of the mechanical emergency lowering
device, the position of the drive is no longer in line with the set
position programming. For this reason, it is necessary to reset
the respective drive to default. In order to do so, just keep hold
of the button “down” at the respective drive until the drive has
been lowered down to the bottom end switch. Now, the drive
has been successfully reset and can be operated as usual.