Boca SoundExpression 14.4VSP, Руководство пользователя

Страница: 40 / 96

40
SoundExpression
4.2 Testing the Connection
1. Check that you have made all connections as instructed in Section Two
(Connecting for Modem Use). Power on the computer.
2. Check for a dial tone on a phone set if one is connected. If a dial tone is
heard, continue. If you do not hear a dial tone, check the connections your
made in the previous subsection, or refer to Troubleshooting (Section 5.2).
3. Install your communications software (see companion software manual)
and place it in command mode. Refer to the communication software
manual for additional information.
4. Start your communications software and enter command mode. If you
are not in command mode, AT commands typed in at the DOS prompt
will result in a “Bad Command or File Name” message.
5. Type in ATZ followed by ENTER and the modem will respond with OK
after a few seconds. If the modem does not respond OK, refer to
Troubleshooting (Section 5.2).
6. Type ATH1 followed by ENTER and you should hear a dial tone from
the external speakers attached to the SE1440. To adjust speaker volume,
refer to your communications software, or use the ATL3 command.
7. Type ATH followed by ENTER to put the modem “on-hook”. This
confirms that the modem has been successfully installed into the
computer.
8. Your modem is now ready for use. Proceed now to your
communications software and documentation.