BobsCNC RP9, Руководство по сборке

Страница: 28 / 45

28
4. Wrap the string around the threaded coupler 3 to 4 times close to the bottom of the
threaded coupler.
5. Insert the large nylon tie with the string attached through the rear string holder and the
loose nylon tie.
6. Snug up the string and slide the bed back and forth to ensure that the sting rides in the
threads of the coupler with full travel ( threads will move up as the bed moves rearward)
7. If needed, adjust the string moving it up or down the threaded coupler.
8. Tighten the sting by pushing the nylon tie into the string holder.
9. Cut off the excess of the nylon ties.
The string should be on the right side of the threaded coupler and form a straight
line as shown in the picture above.