Form
No.
1550-69
r4/20/18 ©
2018
Bobrick
Washroom
Equipment,
Inc. Printed
in
U.S.A.
Page 10
Door Half
Bottom
Hinge
(No Cam)
Stile
Half
Top Hinge
(With Cam)
Cam
#1002156
#1002330
2 x “L”
Hinge Set
Right Hand
Inswing
or
Left Hand
Outswing
Left Hand
Inswing
or
Right Hand
Outswing
#1002331
2 x “J”
Hinge Set
#1002330
2 x “L”
Hinge Set
Cam
Adjustment Points
Stile
Half
Door Half
#1002331
2 x “J”
Hinge Set
Upper Hinge
Lower Hinge
Stile
Stile
Door
Cam
INSTALL HINGES
STEP 8
Fig. 8a: Hinge Configuration.
Fig. 8b: Right-Hand Inswing Door.
Hinge
A. Using hinge diagram at left, identify the upper and lower hinge set for right hand or left hand installation. Locate
#1002156 cam for upper hinge.
B. Separate hinge sets and fasten the 2 halves that have plastic bushings with “teeth” and cam alignment tabs onto stile
using driver and (1/4-20" x 34") screws. Refer to diagram to ensure “J” and “L” halves are located properly.
C. Fasten remaining upper hinge half to door.
D. Insert hinge pin and #1002156 plastic cam on upper stile hinge half.
E. Lift door and position onto upper stile hinge half. Door should be hanging securely on upper hinge.
F. Insert remaining hinge pin in lower door and hinge half and mount to door.
To Increase or Decrease Opening of Door.
A. Alignment tabs have been formed into the cam and plastic hinge bushing.
B. Lift door to limit of upward travel (approximately 1/2"). While door is lifted, raise cam above bottom bushing and rotate
so alignment tabs meet.
C. To set door in open position, rotate cam toward door opening direction.
D. To set door in closed position, rotate cam toward door closing direction.
E. Door may not function properly if cam and bushing tabs are not aligned properly.
F. When the cam has been set at the desired free resting position, “either closed or open” the top of the affixed
components will be aligned
Tip – Industry tolerance in the hardware will sometimes allow fine alignment to some partition components.
These fine adjustments may be performed by loosening the hardware screws and adjusting the components
the direction needed and retightening the screws.
Remove clothes hook, latch, keepers, brass inserts, latch track.
