Form
No.
1550-69
r4/20/18 ©
2018
Bobrick
Washroom
Equipment,
Inc. Printed
in
U.S.A.
Page 6
67-1/2''
(171cm)
41''
(104cm)
64''
(163cm)
Panel
Centerlines
Floor Anchors
14-3/4''
(37cm)
18''
(46cm)
Wall Post
54-1/2''
(138cm)
27-1/2''
(69cm)
64''
(163cm)
18''
(46cm)
Panel
Centerline
64''
(163cm)
43''
(109cm)
Floor Anchors
18''
(46cm)
Stile
Centerline
64''
(163cm)
18''
(46cm)
Panel Centerline
64''
(163cm)
Floor Anchors
Panel Centerline
18''
(46cm)
A. Measure and mark the locations of centerlines for all
the stiles and panels on walls.
B. Using the wall brackets as templates, measure
and mark the location of all mounting holes, plumb
according to dimensions shown in illustrations (Fig.
3a, 3b, 3c).
C. Use #19 (.166) drill bit (4.2mm) for 2" (50mm) deep
pilot holes into adequate wall backing.
D. Secure wall brackets with 1002495 screws.
INSTALL WALL BRACKETS AND WALL POSTS
STEP 3
Fig. 3a: Front-Entry Corner Layout with
Wall Post.
Fig. 3b: Overhead-Braced Alcove Closed
Layout.
Fig. 3c: Floor-Anchored or Ceiling-Hung
Alcove Open Layout.
These mounting points require wall backing.
Obtain Dimension from Bobrick Layout Sheet.
WALL POST #1002250
A. Determine the location and hole of the 1" x 1-1/2"
(25 x 40mm) stainless steel wall post being installed.
Outside edge of wall post to be in-line with outside
edge of keeping stile. The wall must have adequate
backing at mounting location to support door hung in
place.
B. Install wall post at given height and fasten, plumb in
both directions to wall with (5) wall screws provided.
Install (2) post end caps and (5) mounting hole plugs.
C. Attach door with through bolts provided as you install
door(s) on pages 13.