26
SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL
EN
• Travel Adjust
• Sub-Trim
• Reverse
FUNCTION LIST
SERVO SETUP
The Servo Setup menu contains the following functions:
The Main Screen appears when you power on the transmitter. Press the scroll wheel once to display the Function List.
Travel Adjust
Travel Adjust sets the overall travel or endpoints of the servo arm
movement.
To adjust travel values:
1. Scroll to the channel you wish to adjust and press the scroll
wheel. When adjusting travel values assigned to a control
stick:
a. Center the control stick to adjust both directions at the
same time.
b. To adjust travel in one direction only, move the control
stick in the direction you wish to adjust. Continue
holding the control stick in the desired direction while
you are adjusting the travel value.
2. Scroll left or right to adjust the travel value. Press the scroll
wheel to save the selection.
Sub-Trim
Sub-Trim adjusts the servo travel center point.
CAUTION
Use only small sub-trim values or you may
cause damage to the servo.
Reverse
Use the Reverse menu to reverse the channel direction. For
example, if the elevator servo moves up and it should move down.
To reverse a channel direction:
1. Scroll to Travel and press the scroll wheel. Scroll left until
Reverse appears and press the scroll wheel again to save the
selection.
2. Scroll to the channel you wish to reverse and press the scroll
wheel.
If you reverse the Throttle channel, a confi rmation screen appears.
Select YES to reverse the channel. A second screen appears,
reminding you to bind your transmitter and receiver.
CAUTION:
Always rebind the transmitter and receiver
after reversing the Throttle channel. Failure to do so
will result in the throttle moving to full throttle if failsafe
activates.
Always perform a control test after making adjustments to confi rm
the model responds properly.
CAUTION:
After adjusting servos, always rebind the
transmitter and receiver to set the failsafe position.
