The on-board monitor wiring harness
A
is to be laid along the audio or main wiring harness
and secured with cable ties as shown in the figure.
When installing the on-board monitoring wiring harness A start at the earth post X13016
above the left wheel arch.
Screw branch
A10
to the earth post
X13016
above the left wheel arch
Lay branch
A8
to the intended installation site for the left TV amplifier above the left wheel arch
and tie it back (only to be connected if you are also installing a video module and the TV
amplifier)
Branch
A21
to the installation site of the telephone in the rear left side section
Branches
A22
to
A24
to the installation site of the navigation computer in the rear left side
section
Branches
A11
to
A20
along the closing panel from the left-hand side of the car to the right-
hand side of the car
Lay branch
A11
to the intended installation site for the right TV amplifier above the right wheel arch
and tie it back (only to be connected if you are also installing a video module and the TV amplifier)
Lay branches
A16
to
A20
to the intended installation site for the video module in the multi-
functional tray under the spare wheel and tie it back (only to be connected if you are also
installing a video module and the TV amplifier)
Branches
A12
to
A15
to the installation site of the on-board monitor radio in the multi-functional
tray under the spare wheel
Branches
A7
and
A9
to the aerial amplifier above the left wheel arch
The on-board monitor wiring harness
A
runs along the main wiring harness in front of the
rear seat bench to the cardan tunnel and is installed from there to the left of the cardan tunnel
towards the front behind the I-panel to the installation location of the on-board monitor and
fastened with cable straps or textile adhesive strip.
Branch cable
A1
to
A3
to the installation location of the on-board monitor in the I-panel
Branch cable
A4
to the installation location of the light module in the A-pillar, lower right
Branch cable
A5
and
A6
to the installation location of the instrument cluster in the I-panel.
Tie back any excess lengths.
F 53 0715 B
A11
A
A3
A4
A5
A6
A1
A2
A13
A10
A14
A15
A12
A16
A19
A7
A20
A17+A18
A8
X13016
A21
A24
A22
A23
A9
5.
Installation diagram for the on-board monitor wiring harness
EN/9
Retrofit/Installation kit No. 65 90 0 025 169
Issue date: 10.2001
Installation instructions No. 01 29 0 030 090
