Retrofit/Installation Kit no. 82 83 0 022 122 Date: 04.2000
Installation Instructions no. 01 29 0 022 772
Insert hexagon head screw M8x20 (21) from
below into the bracket above (19).
Place the bracket (19) on the amplifier (1) and
screw it in with four fillister-head self-tapping
screws 3.5x9.5 (2).
Take note of the positioning of the
opening (40) for the connector of the adapter
cable.
!
5.
Install amplifier and supplementary wiring harness (mounting system at cross
brace, only vehicles without on-board monitor radio with battery in the boot)
1
2
40
21
19
F 46 0718 B
1
19
23
F 46 0719 B
40
42
20
41
F 46 0720 B
Stick on the damping strips (23) as shown, on to
the top of the bracket (19) and the amplifier (1).
The illustration shows the driver's footwell with
view through the opening of the storage
compartment on the left by the side of the
steering column:
Fix pipe clamp (20) to the cross brace (40) of the
I beam.
Cut insulating mat (41) above mounting screw (42)
of the control unit box and screw out mounting
screw (42).
If the Telestart receiver of a retrofitted park
heating is installed at this position, this will have
to be dismantled first.
EN/40
Screw bottom bracket (18) with existing mounting
screw (40) of the control unit box into the drilled
hole (41) provided.
Do not screw mounting screw (40) in tight
yet as otherwise it will be difficult to slide in the
amplifier.
40
41
18
F 46 0721 B
