BMW 840Ci, Руководство пользователя

Страница: 34 / 161

33
Ov
er
vie
w
Controls
Operation
Maintenance
Dat
a
K
e
yw
ord
Initialising the remote control
This may be necessary for example
after obtaining a new key. The new
transmitter must be initialised before it
can be used.
1 The driver's door must have been
opened with the remote control.
b
If the car was not opened with
the remote control, an interlock is trig-
gered off and remains in effect for
15 minutes with the ignition switched
on.
c
2 Enter the car and close the driver's
door.
3 Turn the ignition key briefly (for not
more than 5 seconds) to position
1, then back to position 0.
4 Press button 1 on the remote con-
trol (see illustration) and hold it
down. Press button 2 briefly three
times in succession within
10 seconds, while button 1 is held
down.
5 Release button 1. The LED will
flash slowly for max. 10 seconds.
6 The central locking system indi-
cates that initialisation has been
performed successfully by closing
and releasing the locks in rapid
succession.
If the LED does not flash and the cen-
tral locking system does not operate,
the initialising procedure must be
repeated.
If you use additional remote-control
transmitters for the same car, each of
them (up to four) must be initialised
within a further 30 seconds (repeat
steps 4 to 6), otherwise they will be
de-activated.
In the event of faults, contact BMW
Service, which can also supply
replacement transmitters.
b
Make sure that the radio remote
control transmitter is not misused, for
example by only handing hotel staff
door/ignition key 3 or the spare key.
c
Interference
The radio remote control may be sus-
ceptible to local interference from
other systems or equipment operating
on the same frequency.
365de1
26
Radio remote control
Online Edition for Part-No. 01 41 9 790 191 - © 12/98 BMW AG