The figure shows the rear right wheel arch from
the inside.
Carefully cut open the light cable loom (30) and
use a measuring instrument to check that the
cables you require can supply the required
signal.
Connect branch
A8
, open cable end, blue/yellow
cable, with double insulation-piercing connector
(6) to the blue/yellow cable you checked earlier
on the light cable loom (30).
Connect branch
A9
, open cable end, grey/yellow
cable, with double insulation-piercing connector
(6) to the grey/brown cable you checked earlier
on the light cable loom (30).
Retrofit/Installation kit No. 65 90 0 151 635 (others see cover sheet)
Issue date: 06.2002
Installation instructions No. 01 29 0 028 872
Secure branch
A4,
suspended 5 A fuse,
red/green cable, on the power supply wiring
harness
A,
to the audio wiring harness (30) using
a cable tie (7).
Lay branch
A5,
black 6-pin socket casing, and
branch
B1,
black 16-pin socket casing, straight,
on the monitor wiring harness, on the carpet.This
will later be connected to the monitor console.
9.
To install and connect the additional wiring harnesses
X18126
7
A4
A5
B1
F 46 1175 B
A6
A7
A
F 46 1176 B
Lay branches
A6
and
A7
on the power supply
wiring harness
A
to the installation site of the
switch module near the
A
pillar at the bottom left.
The remainder of the connection diagram for
branches
A6
and
A7
is described in the
installation instructions headed "Telephone
switch module and Mark IIi navigation system
installation instructions”.
EN/12
A9
6
30
A8
F 46 1177 B
Terminal RS reversing light
blue/yellow
Cable colour
Signal
grey/brown
Terminal 58 (Registration
plate light)
