BMW 2007 X5 3.0d, Руководство пользователя

Страница: 232 / 273

Re
placing part
s
230
Apply the parking brake and engage transmis-
sion position P.
All occupants must leave the car and be led to a
point where they are not exposed to risk, for
example behind a crash barrier at the side of the
road.
If necessary, set up a warning triangle
*
or a
flashing warning light
*
at a sufficient distance
to the rear. Comply with relevant local laws.
Only change wheels on a flat, firm and non-slip
surface. On a soft or low-grip surface, such as
snow, ice, tiles or similar, there is a risk of the car
or the jack sliding sideways.
Position the car's jack on a firm surface.
Never place wood blocks or similar under the
jack, or the maximum support capacity may not
be reached due to the restricted height.
When the car is jacked up, do not lie under it or
start the engine, as this could lead to a poten-
tially fatal accident.
<
What you need
To avoid rattling noises later, please make a
note of the positions of the tools when they are
removed, and replace them in the same posi-
tions later.
The tools are located in the holder beneath the
floor panel flap.
1 Jack
*
2 Crank handle for jack
*
3 Wheel stud wrench
*
Removing compact wheel
The compact wheel is located in the load area,
under the floor panel.
1. Take out the tool holder.
2. Release the wing nut 1 .
3. Take out washer 2 to one side.
4. Take out the compact wheel.
Preparations for changing a wheel
1. Observe the safety notes further above.
2. Slacken off the wheel studs by half a turn.
Thiefproof wheel studs
*
, see page 232 .
Jacking up the car
1. Position the car jack beneath the jacking
point closest to the wheel that needs to be
changed, with the jack base vertically
beneath the jacking point and resting on the
ground across its full surface.
Use the jack only for wheel changing.
Do not attempt to raise another type
of vehicle or any other load with this jack;
this could result in injury or damage.
<
Online Edition for Part-No. 01 41 0 013 209 - © 04/07 BMW AG