NTxx23SDHD Camera-back Transmitter Operation Manual
Broadcast Microwave Services
i
Document Revision History
Initial release
March 2011
Rev. -
Pin assignement for data interface added
August 2011
Rev.
2.0
Conventions Used in This Manual
NOTE: Notes provide supplementary information. They are highlighted for emphasis, as in this
example, and are placed immediately after the relevant text.
CAUTION: Cautions give information which, if strictly followed, will prevent damage to equipment
or other goods. They are boxed for emphasis, as in this example, and are placed immediately
preceding the point at which the reader requires them.
WARNING: Warnings give information which, if strictly observed, will prevent personal injury or
death, or damage to personal property or the environment. They are boxed and shaded for
emphasis, as in this example, and are placed immediately preceding the point at which the reader
requires them.
ATTENTION!
DO NOT use right-angle connectors or adapters on the RF Power Out cable assemblies. Right-
angle connectors may have significant RF power loss at the operating frequencies of this system.
FOR ALL BMS TRANSMITTERS – Operation of a BMS transmitter product generally requires a
license. It is the responsibility of the user to obtain all required operating licenses.
ONLY FOR PRODUCTS AWAITING FCC CERTIFICATION – This device has not been authorized as
required by the rules of the US Federal Communications Commission. This device is not, and may
not be, offered for sale or lease, or sold or leased, in the US until authorization is obtained.
Acceptance Test Procedure (ATP) test data results by product serial number are typically shipped
with all units and indicate the equipment to be operating within advertised specifications. Contact
BMS to request this data.
Read and Follow Instructions! All safety and operating instructions should be read before this
product is operated. All operating and use instructions should be followed. This manual should be
retained for future reference.
EMC Compliance – This equipment is certified to the EMC requirements detailed in the technical
specifications. To maintain this certification, only use the cables supplied or if in doubt contact
BMS Customer Service.
Compliance – This device complies with several standards. Please refer to the chapter 1.5
Specifications, in this manual for a complete list of standards.
