8
Waste Water Tank
This indicates the approximate level in the waste water tank.
If the tank is not installed the indicator will always show full (all level segments will be shown).
When full, all level segments are shown and flashing.
When empty, only the bottom level segment is shown.
Note: If the pump switch is off, the display is not updated; it continues to show the level from
the last time the pump switch was on.
Battery Volts Low
This indicator shows when the battery voltage is at or below 11.0 Volts.
This is user settable, refer to Advanced Configuration section.
Battery Off
This indicator is displayed when switch is in the off position
Water Pump Off
This indicator is displayed when the water pump switch is in the off position.
DESCRIPTION OF SWITCHES AND BUTTONS
Battery Switch
Note:
The Drifter is designed to interface with Setec power supplies. The functionality
described below assumes the Drifter has been correctly connected to such a power supply.
The Battery Switch is used to disconnect the battery from the loads.
In the off position the battery will not power the loads and “BATTERY OFF” is displayed.
In the on position no battery annunciator is shown and the battery will power the loads if no
mains power is connected.
Note:
This switch also enables/disables the USB charging port
Home Button
The Home button is used
› in entering setup modes
› in changing settings
› to turn on the Back-light
Its usage is described in the relevant sections.
Back-light button
The Back-light button is primarily used to enable the back-light. It is also used in entering setup
modes and in changing settings.
10
11
17
16
15
17
11
14
12
8