BM2 BIEMMEDUE GEMINI PLUS, Инструкция по эксплуатации и техническому обслуживанию

Страница: 48 / 52

Use a
MAINTENANCE
■ Possible failures - causes - solutions
Problems Causes Solutions
Poor suction • The air filter is dirty
•
The rubber scrapers of the
cleaning brush have not been
fitted correctly
• Low suction power of the
machine
• The flexible hose is clogged
•
The water drain hose is
clogged
•
The level of clean water in the
tank is too high (above the
Clean the filter
Check they have been
fitted in the direction shown
by the arrow (fig. 15, page
14) Operate button
M (fig.
11, page 12) on the handle
and increase the suction
power
Disconnect the hose from the
machine and eliminate any
dirt
Eliminate any impurities from
the drain hose (fig. 33, page
24)
Empty any water in excess
Anomalous noise of the
motor • The water in the dust collecting
tank is at max level
Drain water off the dust
collecting tank
Extension wands or
accessories come loose
easily
•
The locking lever is not
blocked Shift the lever to position 1 (fig.
5, page 10)
Extension wands or
accessories are hard to fit
• The connecting gaskets
produce friction
•
The locking lever is not in the
central position
Lubricate the gaskets with
some oil
Turn the lever to the
central position
The iron releases water
instead of steam • The thermostat is set to a low
level
•
Once the thermostat has been
set, you didn’t wait for the iron
to warm up
Adjust the thermostat within
the white area
Wait as long as necessary
The red light indicating
that the tank is running out of
water, comes on
• The water reserve has been
used Replenish and wait for 30
minutes. If the light does not
go off, contact the Service
Centre.