Blunik Trip II PLUS, Руководство пользователя

Страница: 43 / 61

· 42·
Examples:
6.18. EXTERNAL REFERENCE MEASURE CHANGES
In some rallies we have to change measurement at points where the distance
is not given. The point is only indicated using a photo or a Figure in the Road
book (external reference).
When programming the Stage:
We program the measures normally.
Putting 000k000 at the unknown distances.
During the Timed section ( BLUNIK Active )
When the next measurement change is unknown, the BLUNIK II tells us by
displaying START! in the part of the screen corresponding to the imposed
measure.
Exactly as we pass each of the external reference points we press
The distance measured on pressing
START will immediately be entered in
the position that had been programmed as 000k000 and the BLUNIK II will
recalculate the delay or advance depending on the measurements.
If on pressing
START we are behind the measurement will immediately
change and recalculate retroactively. If on pressing START we are ahead
the measurement will change later.
6.19. UNKNOWN MEASUREMENT CHANGES
When we are not given one of the measurements of a partial until we reach
the point at which we must change.
When we are not given one of the measurements of a partial until we reach
the point at which we must change.
During the
Timed section ( BLUNIK Active )
By pressing ST we change the corresponding measurement and press
The BLUNIK will make the corresponding calculations.
Blue Decal Corr
0.3s +00.0s 02mt Precision Rally.
1.0s +00.0s 10mt Timed GPS rally.
1.0s -00.5s 10mt Timed GPS or Manual rally.