29
V1.1
SmartBus P900-TI6N USER MANUAL
L
E
D
7. The keypad audible indicator will sound on and off for the duration of the
EXIT
delay.
8. Any bypassed zones will be shown by the flashing zone indicators.
9. Leave the premises only via the
EXIT/ENTRY
zone.
10. During AWAY arming, the telephone line will be supervised hourly. If the telephone line is
disconnected, a new trouble condition will be registered (please refer to View System
Trouble at page 24).
11. User will be given an
ENTRY
delay time to disarm the system when enter the protected
premises via
ENTRY/EXIT
zone.
12. It is also possible to AWAY arm by simply press and hold down key
[1]
for 2 seconds.
[1] + [1 or 2]
(Press and hold down for 2 seconds)
13. Zone indicator
[1]
and
[2]
will flash.
14. Press key
[1]
followed by key
[2]
to arm both partitions.
If your user code has access to 2 partitions and you would like to arm Partition 1 only
[
] + [USER CODE] + [#] + [1] + [#]
(Leave via ENTRY/EXIT Zone)
If your user code has access to 2 partitions and you would like to arm Partition 2 only
[
] + [USER CODE] + [#] + [2] + [#]
(Leave via ENTRY/EXIT Zone)
1. Ensure that all zone indicators are distinguished; if not, check that all protected premises
are closed.
2. Press the
[
]
key to cancel any unintended entries.
3. Enter a valid 4-digit
[USER CODE]
. If you enter mistakes, press
[*]
key and re-enter the
code
followed by
[#]
key to confirm your command.
4. Zone indicator
[1]
and
[2]
will flash.
5. Select the partition number that you wish to arm followed by
[#]
key.
8.14.2 AWAY ARMING EITHER 1 PARTITION
