RGTNB 2008
BEFORE YOU TURN IT ON….
•
As part of the installation protective plas-
tic wrappers on stainless steel surfaces
should be removed. These wrappers must
be removed before operation.
•
New appliances are wiped clean with vari-
ous cleaners and solvents to remove visi-
ble signs of dirt, oil and grease before
leaving the factory. After installation,
performance checks and adjustments, the
appliance should be allowed to heat to
burn off any such oils from internal parts.
The presence of such coatings is normal
as part of the manufacturing process. The
ventilation hood should be turned on and
the area well ventilated to allow fumes to
escape safely.
•
Removable parts should be washed with
hot soapy water, well rinsed and wiped
dry.
•
Complete and mail your Performance
Checklist to validate your warranty.
BURNERS
•
Remove the top grates and thoroughly
wash them with hot soapy water, rinse and
wipe dry. Extended exposure to moisture
may cause these cast parts to rust.
•
To light a burner turn the corresponding
control knob to HIGH.
•
This knob is a gas control valve and an
electric switch. Turning to the High posi-
tion begins the ignition sequence.
•
The ignitors begin to “click”. As gas
flows through the piping to the burner the
sparking ignites it. After the flame lights
the ignitor senses its heat and the
“clicking” automatically stops.
•
ALL burners light at the HIGH setting.
•
Burners are equipped with a re-ignite fea-
ture in case the flame is extinguished for
any reason.
•
At the High setting, flames should be
sharp with blue tips. Some yellow may
appear depending on the type of gas being
burned.
•
Turn the flame lower so it does not wrap
around the bottom edge of the pan.
•
Burners may be operated at any knob po-
sition between LOW and HIGH.
•
Never operate the burner with the knob
between the HIGH and OFF position. If
the flame goes out it will not re-ignite and
gas leaks could occur.
•
When you turn the valve off the flame
may linger several seconds until all the
gas in the feeder tube is burned up.
GRIDDLES
•
New griddles must be seasoned prior to
their first use.
•
Remove all factory materials and wash the
griddle plate with hot soapy water. Rinse
and dry thoroughly.
•
Apply a light coating of unsalted peanut
oil to the top, sides and front of the grid-
dle plate. Wipe away any excess oil.
•
To light the burner turn the knob counter
clockwise to the medium setting.
•
When the griddle is lit turn the heat set-
ting back to “LOW”.
•
After a short while as the griddle heats it
likely will discolor with the heat. Colors
range through different shades of blue and
black. This is a normal characteristic of
griddle plates and should be expected.
•
After approximately 30 minutes, wipe
away the oil and apply a second coat.
Wipe away the excess.
OPERATION
NEVER use this appliance as a space
heater to heat or warm the room. Doing
so may result in carbon monoxide poison-
ing and overheating.
Содержание RGTNB
Страница 6: ...RGTNB 2008 SITE PREPARATION ...
Страница 8: ...RGTNB 2008 INSTALLATION Range top Dimensions for RGTNB ...
