BlueStar RGTNB, Инструкция по установке и эксплуатации

Страница: 10 / 25

RGTNB 2008
BACKGUARD
All range tops require a backguard. Most
models have the option of using: an island
trim; 7 inch standard; 17 inch hi-back; 21 inch
high shelf. Heritage Classic models require a
21 inch high shelf for all installations.
If you are using an island trim a six inch
clearance between the back of the range and a
combustible surface is required. If an island
trim is to be used without this six inch clear-
ance the back wall must be non-combustible
and heat resistant material that extends below
the top surface of the range a minimum of six
inches.
All backguards follow the same basic installa-
tion. Using hardware supplied, align the
backguard with the wrap around on each side
and slip the tongue into place. A minimum of
six sheet metal screws (more depending on
width) are to be installed, three on each end
and more along the bottom edge.
Remove the two rear ring grate/top grates
from the cooktop surface. Four sheet metal
screws are to be installed - down - into the
cooktop support. Two screws are installed on
each end ring grate/top grate position. Re-
place the removed grates.
If you are installing a high shelf there is an
additional channel to be installed on each side
first. The back guard then slips over this
channel as you put it into position. This chan-
nel provides extra support for the higher rise
of the 21 inch back.
INSTALLATION