902-290 6’ Sectional Slide
902-135: TEN RUNG WALL
Page
11
Rev. 1/22/04
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
www.sportsplayinc.com
KKJJJ
SPECIFICATIONS
PARTS LIST
Event:
Ten rung walls act as a
barrier to prevent falls from decks.
Horizontal pipes that fit into post
clamps are 1 3/8” O.D. Vertical
pipes are 1” O.D.
Paint:
shall be electrostatically
applied polyester dry powder coating
Hardware:
shall be a combination
of zinc-plated, stainless steel and
aluminum.
Ref Description QTY
A Wall 1
B Clamps 4
Hardware
MAINTENANCE:
•
Touch up any marred paint
surfaces.
•
Periodically check hardware for
integrity and tightness.
INSTRUCTIONS
:
-
The ten rung wall is 48” wide and attached with (4) clamps making sure you have evenly spaced the wall
on both sides making sure there is less than 3 ½” between the post and end rungs. Test with torso probe.
-
It is attached on the “deck side” of the deck posts with the top rail 38” minimum over the deck surface
making sure there is less than 3 1/2'” between the deck surface and the bottom of the wall. Test with
torso probe.
-
Follow the step-by-step directions.
-
If mounted outside the posts or off the deck surface there has to be a maximum of 3.5” between the
bottom of the wall and the top of the deck.
-
It is a good idea to put a couple of equal sized shims under the wall while installing.
-
Level the wall.
-
Review the clamp instructions for sideways attachment of clamp.
FOOTING DIAGRAM:
A
B
