Blue-White industries CHEM-PRO ProSeries C3 Series, Руководство пользователя, Страница: 5 / 32

5.0 Installation
5.1 Mounting Location
Choose an area located near the chemical supply tank, chemical injection point,
and electrical supply. Install the pump where it can be easily serviced.
!
Mount the pump to a secure surface using the enclosed hardware.
!
Mount the pump close to the injection point. Keep the inlet (suction) and outlet
(discharge) tubing as short as possible. Longer discharge tubing increases the
back pressure at the pump head.
!
Your solution tank should be sturdy. Keep the tank covered to reduce fumes. Do
not mount the pump directly over your tank. Chemical fumes may damage the
unit. Mount the pump off to the side or at a lower level than the chemical
container.
!
Be sure your installation does not constitute a cross connection with the drinking
water supply. Check your local plumbing codes.
CAUTION: Always wear protective clothing, face shield, safety
glasses and gloves when working on or near your metering pump.
Additional precautions should be taken depending on the solution
being pumped. Refer to MSDS precautions from your solution
supplier.
Typical Installation
Foot Valve
Page 4 Page 5
C3 C3
CHEM-PRO
TM
tm CHEM-PRO
C3V | Diaphragm Metering Pump
Made in the USA
MODE
PRIME
Program
Minimum
Maximum
Blue-White Ind. IP66
NEMA 4X
Parts Locator
Mounting Bracket
Control Panel
Pumphead
Inlet (suction)
Outlet (discharge)
Junction Box
Priming and
Degassing Valve
tm
E
R
-P O
CH M
D p
C
M e
r m
i g P
i
a
r
m
3
h g
e
n
V
a
u
t
p
|
e i
h tS
Mad
e U n
A
E
MOD
P I R ME ra
P
g m
ro
M n
m u
i i m
ax M
u im m
u
h
In
l
e
.
e W
t
-
d
B
i
P I 6 6
M N
4X
A E
Suction Tubing
Injection /
Check Valve
Chemical Tank
Priming /
Degassing Tubing
Discharge Tubing
n
Raise metering pump 4-1/2 inches (11.43 cm)
off the ground or a surface.
n Made out of tough Stainless Steel.
n
Provides a stable mounting surface.
Blue-White’s Stainless Steel extended brackets allow the pump to be securely mounted to most
any surface; floor, shelf, or skid. The brackets lift the pump up 4-1/2 inches (11.43 cm), allowing you
to easily connect the suction side of the pump to your solution.
Model #
72000-380
Description
Extended Mounting Bracket, 1 Pair, SS, 4 SS Screws
Note: All diagrams are strictly for guideline purposes only. Always
consult an expert before installing the pump into specialized systems.
The pump should be
serviced by qualified persons only.
4.0 Unpacking
Your pump package should contain the following:
1 - Metering Pump
1 - 8 foot / 2.4 meter suction tube, clear PVC
1 - foot valve & strainer assembly
1 - Injection fitting with internal back-flow check valve
1 - Mounting hardware kit (two mounting brackets, 4 screws)
1 - 5 Foot / 1.5 meter Priming Tubing
Extended Brackets
Model Number 72000-380