3.11
3.15
3.12
3.6
3
4
5
1
2
Identify one of the half bottom riser parts. With the warning signs facing out, away from the steps, fit the bottom
riser into the indentation of the stringer at
POSITION 1
(see Detail 3.6 & 3.8). Press the bottom riser into the
stringer until the button lock knob on the end protrudes through the hole and locks the part in place (see Detail
3.10). Identify one of the half top tread parts. With the anti-skid surface facing up, fit the top tread into the
indentation of the stringer at
POSITION 5
(see Detail 3.6 & 3.9). Press the top tread into the stringer until the
button lock tabs on the end protrudes through the holes and locks the part in place (see Detail 3.10)
3.9
3.10
3.8
1
2
2
3.13
3.14
Identify one of the tread-riser parts (without light hole) and lay it on a flat surface. Holding the tread portion in place, fold the riser portion
over (see Details 3.11 - 3.13). Make certain to fold warning signs on riser portion toward anti-skid surface of tread portion. You can over fold
until portions touch as they will want to go back to their original position once you let go. Take the folded tread-riser and fit it into the
indentations of the stringer at
POSITION 2
(see Detail 3.6, 3.14 & 3.15).
Note
: the tread portion with two button lock knobs will fit into
the horizontal indentation in the stringer just above the half bottom riser already installed. The riser portion will fit into the next indentation
above it. Press the tread-riser into the stringer until the button lock knobs on the ends protrude through the holes and lock the part in place
(see Detail 3.10). Similarly, take the tread-riser with light hole, fold the part and insert it into indentations at
POSITION 3
. Take the last
tread-riser (without light hole) and complete the assembly of the treads and risers. Make certain all button lock knobs secure parts in place
With all treads & risers securely installed into the right stringer, position a
left stringer (Detail 4.1 & 4.2). Similarly, the indentations in the left
stringer fit over the ends of the treads and risers; align the button lock
knobs with the holes in the stringer & press the stringer down locking all
parts together. Make certain all knobs are locked through stringer holes
(see Detail 3.10). Stand completed step assembly upright (Detail 4.3).
The top of the stringers, where the upper handrails fit within, are open to
the internal hollow cavities. One side of the pool entry requires additional
weight for ballast & to prevent the step from floating. Put approximately
10-15 lbs of clean gravel into both the left & right stringer. This will give
one half of the step system the required stability within the pool. Repeat
for the assembly for the second step system but
DO
NOT
add weight
Step 4: FIT OPPOSITE STRINGER & ADD WEIGHT
4.2
4.1
4.3
4.4
FOLLOW ALL ASSEMBLY INSTRUCTIONS FOR A
SAFE AND STABLE POOL STEP SYSTEM.
USE OF A STEP PAD IS HIGHLY RECOMMENDED
5
