13
POOL ASSEMBLY INSTRUCTIONS (CONTINUED)
12.
FOR 15’ & 18’ ROUND POOLS ONLY!
Look through the hole in the vertical leg of the T-Fitting as you
insert the Vertical Leg. Rotate the leg until the holes in the Vertical Leg and the T-Fitting align.
TIP:
A
Philips screwdriver can be helpful in aligning the holes. Insert the pins through the holes until they snap into
place. Continue until all Vertical Legs are connected and pinned to the T-Fittings.
13.
Go around and check all fittings, legs, and beams are properly installed and secured in place. Make sure the
drain fitting is plugged securely and the cap is in place.
14.
Fill up the pool with about an inch (1”) [2.54cm] of water. Stop filling and smooth out all wrinkles from the
pool floor, working outwards from the center, so that it fills evenly.
Note:
If more than one to two inches (1”-2”) [2.54cm-5.08cm] of water collects on any one side before the pool
starts filling in the center, the pool is not level enough, and must be corrected.
15.
Before adding additional water you must install the thru-wall water intake and returns fittings and connect
the filtration system as per the filtration system instruction manual.
16.
Once you have completed the assembly and attachment of the filtration system you can continue to fill the
pool. Add water to a minimum of six inches (6”) [15.24cm] below the top rim.
NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY. THE POOL MAY LEAN
TO ONE SIDE AND COLLAPSE. THE VERTICAL LEGS MUST BE STRAIGHT AND VERTICAL TO THE
GROUND. IF YOUR POOL IS LEANING, THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO
START OVER.
DANGER! FAILURE TO FOLLOW THE GROUND PREPARATION AND ASSEMBLY INSTRUCTIONS ABOVE
WILL CAUSE YOUR POOL TO COLLAPSE, POSSIBLY CAUSING FLOODING DAMAGE OR INJURY TO
SWIMMERS. A POOL THAT COLLAPSES DUE TO NOT BEING LEVEL WILL VOID THE WARRANTY.
