8
9
CONTENTS
- The icemaker is designed for indoor use only.
- Level the icemaker from side to side and front to rear by adjusting the legs.
Location should provide a firm and level foundation for the machine.
- The icemaker should not be located next to ovens, grills, or other high heat producing equipment.
- The legs must be installed before starting the machine.
- After installation, make sure that all the components, fasteners, and screws are all fixed in proper
positions. Check if any of them fell into the storage container.
Please read the following cautions;
- The Icemaker must have the earthwork done.
- The Icemaker must have exchangeable fuse or circuit breaker.
- Decide the appropriate size of the wire based on the length, thickness, and position of the wires.
- Above work has to be done by a qualified electrical engineer.
NOTE : The icemaker requires no clearance at either side. But allow approximately 5” (12cm)
at rear for water supply and drain connections.
2.2 Electrical Requirements
WARNING
- All kinds of power wiring work including power cable connection and earth have to be done
in accordance to the law and regulations of the Country, State, and District.
- The earthwork for icemaker has to be done in accordance to the law and regulations of the
Country, State, and District.
●
Voltage
- When operating the icemaker (with maximized electrical load) range of variation in maximum
voltage allowed is +10%/-5% of the rate voltage.
- Specification of the power cord when released from the factory is 6.5’ (2.0m) with NEMA 5-15P Plug.
●
Fuse/Circuit Breaker
- Must have the exclusive fuse/circuit breaker for the icemaker.
- As for circuit breaker, US HACR (Heating, Air Conditioning, and Refrigeration) type must be used.
●
TOTAL CIRCUIT AMPACITY
- For details about size of cable for power supply, please refer to the “1.1 Technical Specification.”
