Blue Giant EPJ-60R, Руководство пользователя

Страница: 55 / 94

10-3.PUMP MOTOR.
The pump motor is replaceable but not repairable.
Refer to paragraph
9-2.
10-4.DRIVE MOTOR.
The drive motor exposed surfaces should be cleaned
at least once a month to assure proper cooling of
motor. Use an air hose to blow dust off of motor sur-
faces.
10-4.1.Motor Removal
1. Remove the brake as described in paragraph
6-1.3.
2. Note routing of cables to ensure proper installa-
tion.
3. Tag the cables connected to the drive motor; then
disconnect these cables from the drive motor.
4. Remove the four screws (34, Figure 10-6 ) and lift
motor (48) from the transmission.
10-4.2.Motor Installation
5. Install drive motor (48, Figure 10-6 ) on the trans-
mission (12). Make sure to align the gears.
6. Reinstall four screws (34).
7. Position cables as noted in removal and recon-
nect the cables to the drive motor.
8. Reinstall the brake as described in paragraph
6-1.3.
10-5.LIFT LIMIT SWITCH
10-5.1.Replacement
1. Disconnect wiring from the lift limit switch (21, Fig-
ure 10-2 ).
2. Remove the two screws (17), two lock washers
(18), flat washers (19) and switch (21).
3. Remove the two nuts (26), two screws (22), two
lock washers (23), flat washers (24), and mount-
ing plate (25) from the switch.
4. Position the new switch on mounting plate (25)
and secure with two screws (22), two lock wash-
ers (23), flat washers (24) and two nuts (26).
5. Position bracket (25) on the frame and secure
with two screws (17), two lock washers (18) and
two flat washers (19).
6. Adjust the switch as described in paragraph
10-5.2.
Figure 10-6 Transmission, Motor, Brake Assembly
10-5.2.Adjustment
1. Raise the forks until switch (21, Figure 10-2 ) is
aligned with the detent on the frame.
2. The detent should trigger the lift limit switch and
stop the hydraulic pump and motor.
3. If necessary, loosen screws (17) and adjust
mounting plate (25).
4. Tighten screws (17) and recheck.
R6783