Blue Giant EPJ-60R, Руководство пользователя

Страница: 41 / 94

SECTION 8
ELEVATION SYSTEM SERVICING
8-1. LIFT LINKAGE
8-1.1. Removal
1. Lift complete truck to height sufficient to permit
access to lift linkage under forks. Provide blocking
under frame (3,
Figure 8-1 ), the rear of fork frame
(15) and at tips of the forks.
2. Turn off the key switch (13, Figure 12-13 ) and dis-
connect the batteries.
3. Remove pin (6, Figure 8-2 ) and remove shaft
(18). Lower the front of link (9) to the floor.
4. Remove pin (6) and remove shaft (5). Free the
front of link (8) from the fork frame.
5. Remove two pins (3) and remove shaft (2). Free
the rear of link (8) from the main frame.
6. Remove the link assembly from under the fork.
8-1.2. Repair
1. Remove pin (3, Figure 8-2 ) and shaft (13). Free
bracket (17) from bar end (12).
2. Inspect bushings (4) in bar end (12). If necessary,
remove and replace the bushings.
3. Remove pin (3) and shaft (14). Free roller (16)
from bracket (17).
4. Inspect bushings (15) in roller (16). If necessary,
remove and replace the bushings.
5. Remove pin (3) and shaft (7). Free bar (9) from
link (8).
6. Inspect bushings (4) in link (8). If necessary,
remove and replace the bushings.
7. Reassembly by reversing the steps above.
8-1.3. Installation
1. Position the link assembly from under the fork.
2. Position the rear of link (8, Figure 8-2 ) in the main
frame and install shaft (2) and two pins (3).
3. Position the front of link (8) in fork frame. and
install shaft (5) and pin (6).
4. Position link (9) in the fork and install shaft (18)
and pin (6).
5. Remove blocking and lower the truck to the
ground.
6. Reconnect the batteries and turn on key switch
(13,
Figure 12-13 ) .