PE3M Small Form Factor PC
Upgrading the System Hardware
Page 25
DIMM Sockets
Hard Drive Assembly
Fixing Screws
Hard Drive Assembly
Locating Tabs
Remove the hard drive assembly as follows:
Remove two screws from the rear top face of the chassis.
Lift the rear end of the hard drive bracket a little, and slide the bracket towards the rear to disengage the two
tabs at the front end.
Lift the drive assembly and disconnect the hard drive power lead connector.
Remove the hard drive UDMA ribbon cable from the Primary IDE connector (IDE1, blue) on the
motherboard.
Disconnect the CD/DVD ribbon cable from the Secondary IDE connector (IDE2) on the motherboard.
The two DIMM sockets are then accessible.
Plug in the memory making sure that it is fully seated and that the end clips are located into the notches in the
memory circuit boards.
Re-install the CD/DVD ribbon connector to connector IDE2.
Refit the hard drive UDMA cable to the motherboard connector IDE1.
Refit the hard drive power cable connector.
Refit the hard drive assembly.
Replace the top cover.
When the unit is powered up, the memory will be automatically detected and reported.
