10mm 3x2 Residential Middle
B10-MW-150
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-MW-150)
Remove the four walls and four triangular corner
bracers from the sprue. Glue the triangles to
non-etched side of the two long walls as shown
in the example above. Leave to dry.
Once the bracers are dry, apply a little glue to the side
lugs and glue the shorter walls in place as shown
above. You should now have a hollow square
structure. Leave it to dry.
Now remove the four rectangles from the sprue.
Each of these has a line etched across it. Apply
glue to one side of the line only and attach it (as
shown) to the centre
bottom
edge of each wall.
Finally glue the balconies into position.