28mm Middle Eastern Building #10
B28-ME-010
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four inner walls and base from the sprue.
Glue them together as shown to form an open-top
box.
At this point it is a good idea to glue a weight to the
inside of the box to help the minarets stability. We
have used a number of Uk 2p coins.
Glue the
“lid” in place.
Glue to the doorway arch to the box, so that its right
hand side is flush with the edge and it sticks out by
about 2mm on the left hand side.
Move around the box, adding the other outer wall
pieces. Leave this sub-assembly to dry.
Take the sides of the tower, two supports and the
end caps from the sprue.
Glue the four walls with lugs on the ends to the
supports, ensuring that all have the long lug at the
same end..