10mm 3x2 Residential Foyer
B10-MW-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-MW-100)
Start by removing the sections shown above (left)
from the sprue. There are enough parts to create
both doorway sections.
Glue them together as shown in the image on the
right.
Glue each doorway to the
back
of the long sides, using
the lugs/holes provided.
At the same time, glue a triangular bracer to the
back of the long sides at each end. Leave these to
dry.
Glue the shorter end walls into place to give a hollow
rectangle. Once this is dry, glue the decorative
columns and balconies into position.