Bloomfield 9600 Single Cup, Руководство пользователя

Страница: 10 / 28

Fig. 5 Program Brew
Select Keys
Table I.
FOUR BREW OPTIONS
OPERATION (continued)
8
B. PROGRAM BREW VOLUMES
♦
Each BREW SELECT KEY is individually
programmable.
♦
Keys may be programmed for pulse brewing to optimize
contact times and extraction rates,.
♦
Up to 10 pulses may be programmed. Each pulse delay is
fixed at 4 seconds.
♦
Dilution for each BREW SELECT KEY is individually
programmable (usually used for brewing tea).
1. Load a fresh pod in the pod holder and lock the pod in place. Place
an empty cup on the cup grid. See page 9.
2. Press and hold both BREW SELECT KEYS for 5 seconds until a
beep sounds.
3.
Program BREW 1 SELECT key
IMPORTANT: Allow for an additional 2 oz to be pushed
through during the drying cycle at the end of the brew.
a. Press and release the key to start water flow.
b. Press and release the key to stop water flow when desired
volume is reached. Press and hold the key for 3 seconds
(until a beep sounds) to enter the setting into memory.
- OR -
For PULSE BREW:
a. Press and release the key to start the water flow.
b. Press and release the key again to stop the flow after the time
desired for the first pulse.
c. Press the key again to resume water flow.
d. Repeat until desired total delivered volume is reached.
NOTE: Water flow can be stopped and restarted up to 10 times per
brew. The delay between pulses is fixed at 4 seconds.
- AND -
For DILUTION:
a. Press and release the BREW 2 SELECT KEY to start hot water
flow at any time during the programming sequence.
b. Press and release the key again to stop the flow when the
desired amount of hot water is reached.
4.
Press and hold the BREW KEY for 3 seconds (until the beep
sounds) enters these settings into memory.
NOTE: Pod must be refreshed before operation can resume.
5.
Repeat steps 1 through 4 for BREW 2 SELECT KEY.
NOTE: In this mode, BREW 1 SELECT KEY is used to program
dilution.
6. Run a normal brew to verify settings.
NOTE: Pump is factory programmed to run for 15 seconds at the end of
the brew cycle. Pulling air from the vent tube will dry the used pod.