EN
10
3
Installation
3.1 Appropriate installation
location
Contact an Authorized Service
for the installation of the product.
In order to prepare the product
for use, refer the information in
the user manual and ensure that
electrical installation and water
installation are appropriate. If not,
call a qualified electrician and
technician to have any necessary
arrangements carried out.
B
WARNING:
Manufacturer
shall not be held liable for
damages that may arise
from procedures carried
out by unauthorized
persons.
B
WARNING:
Product
must not be plugged
in during installation.
Otherwise, there is the risk
of death or serious injury!
A
WARNING:
If the door
clearance of the room
where the product shall be
place is so tight to prevent
passing of the product,
remove the door of the
room and pass the product
through the door by turning
it to its side; if this does
not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves and
at least 5 cm away from electrical
ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall, pay
attention to leave at least 5 cm
distance with the ceiling and side
walls.
• Your product requires adequate
air circulation to function efficiently.
If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between the
product and the ceiling, rear wall
and the side walls.
• If the product will be placed in
an alcove, remember to leave at
least 5 cm clearance between
the product and the ceiling, rear
wall and the side walls. Check if
the rear wall clearance protection
component is present at its location
(if provided with the product). If the
component is not available, or if it
is lost or fallen, position the product
so that at least 5 cm clearance shall
be left between the rear surface
of the product and the wall of the
room. The clearance at the rear is
important for efficient operation of
the product.